自攻螺絲常見問題主要包括以下四點
一,自攻螺絲頭部變形。造成這種問題很有可能是我們?cè)谏a(chǎn)的過程中螺絲模具中一沖沒有放好位置或者是調機不當。
二,自攻螺絲的頭部打的不圓。這個問題也是在緊固件公司生產螺釘?shù)倪^(guò)程中經常會出現的,一般是螺絲模具一沖模在成型的時候沒有飽滿。
三,自攻螺絲帶有一些毛刺。這個主要是模具一沖成型沒有做好,當沖棒比較短就會造成這樣的問題。
四,自攻螺絲的頭部出現了裂縫。這樣有可能是螺釘?shù)木€材不合格導致的,因此我們?cè)谏a(chǎn)螺絲之前,一定要對于螺絲線材進行嚴格的檢測,當我們發現不合格的線材一定不要進行生產。比如我們?cè)跈z測的時候各個數據一定要出來,這樣才能夠判斷線材的合格與否。還有的問題就是模具一沖放錯了和忘記了放潤滑油等等